strange indicator fault

[steve.s]

Hi All

Vin 1621 back on the road again with a rebuilt front caliper. did it myself to make sure of a good job!.

now the indicators have packed in. occassionally work, but most of the time nothing..no click etc.

but the hazards work fine.

do these feed through the same earth?.

i know first will be the fuse to see if its ok or dirty contacts. next the column connection and switchgear.

anyone else had this fault?

[bozzzydmc]

Check the electrical connector block is correctly seated on the back of the hazard warning switch matey.

[Glen & Sam]

hi

mine does the same its ullsay a dry joint in the relay box behind the dash in the driver side i have done mine 3 times know but i going to buy a new one

[steve.s]

thanx all will check

is it like an mx5 i had...if you remove the hazard switch then the indicators were dead....it seemed to take a feed of this switch.

just wondered if the D is the same?.

Regards

[Glen & Sam]

yep its works i think the same way as i can remember doing it to mine when ikind of had a melt down poblem with mine :roll: