I like the standard DeLorean just as much as the Time Machine from BTTF. I was wondering if any members have managed to convert their standard DeLorean into the time machine without drilling holes and damaging it ect? I am trying to find everything I would need to do it myself but I am struggling. I know Bob's prop show is the most obvious place to go but he doesn't sell everything i'd need (like the main time machine dash panel) and he would only do it if I sent mine over there, which I don't want to do as he'd drill holes in it! I asked him if he'd sell me all the bits but he said no!
So really I am looking for a one stop shop to buy everything as a kit. Help anyone please, can this be done, has anyone tried?
You don't have to drill holes, I didn't but then again, mine didn't have every single bell and whistle…but it was pretty good. If you want to see it now, go to Gaydon and have look. I changed it all over to a cheaper, Auto car before I sold it.
Chris Parnham
Ex RHD Auto's etc.etc
Main Car.. Kia E Niro 4+
Skoda Yetil 4X4.
Toyota Vitz 4X4 1999 (the smallest 4X4 by far!.
1970 Jago Jeep.
Mikes is the best non holes time machine I've seen. It's very accurate, especially for a non hole conversion. There is just one part which you really do need to drill and that's the t panel. Those flux boxes are solid resin, and with the weight of the bars on them and the additional two flux boxes under the rear bumper, it would be lunacy to drive on public roads IMO without doing this. Used t panels can be found quite easily.
O[attachment=59][attachment=59]Thanks, guys. I haven't been on here for a while but yes my car is close as you can get to the original car without drilling a single hole. I made templates for the interior and exterior of the car and my claim to fame is is can be put back to a stock delorean within an hour ?
[attachment=59 Wrote:I'mDeloreanyorkshire pid='46306' dateline='1454436748']Thanks, guys. I haven't been on here for a while but yes my car is close as you can get to the original car without drilling a single hole. I made templates for the interior and exterior of the car and my claim to fame is is can be put back to a stock delorean within an hour ?
I can't seem to work out how to but pics on properly on here But here is another one
But here is another one
