Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cat removal
#1
I am wanting to fit the by pass pipe and before getting started I was looking for any possible advice or tips.

I had a quick look today and cat figure out how to get to the bolts to loosen the CAT.

Is there a knack to it or another case of grow an extra few fingers and grin and bear it.

Cheers.
Paul Jenkins
Vin 2493
Belfast
Reply
#2
Luckily I have the use of a pit so I could access it from underneath the car.
You can get to all 4 nuts on the back of the manifold using a socket set extension bar and a universal joint.
I would recommend an air gun to whizz them off.

NickT.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)